![]() Choose a WiFi channel according to the busyness of other channels. The General Setup section is used to turn a wireless device on or off, select the operating frequency (WiFi mode and channel), transmit power and define a country code.Ī wireless 2.4 GHz WiFi channel requires a signaling band roughly 22 MHz wide, radio frequencies of neighboring channels numbers significantly overlap each other. You can find this section by clicking the 'Edit' button next to a wireless device ( not an interface) in the Network → Wireless page: The Global Settings section is used for configuring WiFi hardware parameters. To configure your Wireless device as Client press Scan button to scan the surrounding area and attempt to connect to a new wireless access point. You can also configure your WiFi devices by clicking Edit button Here you can turn on or off your WiFi interfaces, remove them or start configuring by clicking onĮdit button on the right side of interface. It displays active access pointsand stations. The WiFi 2.4 GHz section is used to configure your wireless access points (AP) and wireless clients (STA).Ībove is the overview of the Wireless Overview window. RUT200 devices support IEEE 802.11b/g/n and 802.11e_WMM wireless technologies. ![]() You can do that by clicking the "Basic" button under "Mode", which is located at the top-right corner of the WebUI. If you're having trouble finding this page or some of the parameters described here on your device's WebUI, you should turn on "Advanced WebUI" mode. This chapter of the user manual provides an overview of the Wireless section for RUT200 devices. ![]() The Wireless section of the Network tab can be used to manage and configure WiFi Access Points and WiFi Stations (clients).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |